Notepad++ Cura and Gcode Syntax Highlighting.

Obviously I have been playing with gcode since I have been doing some 3dprinting. I finally got the user defined[…]

BitFenix Spectre RGB Case fan wiring and Review

Thanks to a really old motherboard that went out I just acquired a new Asus ROG Crosshair VI Extreme motherboard[…]

I had a shelf that was pretty bland. Couple that with the fact that I had a SmartThings Arduino Shield[…]

The price finally came down enough in order for me to splurge and get the solo drone from 3DR. I[…]

I started another project recently to control the arduino with voice commands. I decided for this one I would do[…]

So in my last post I mentioned that we were going to continue with trying to figure out our small[…]

This is Part 2 of my wheelchair hacking project. Part 1 can be found here. After reading my last post[…]

Recently I got into microcontrollers and to make a really long story short I decided to attempt to control a[…]

I have played with RC for a long time, of course when I was a kid I had those cheap-o[…]

So we got a wild hair up our bum and went and bought a new camper. This will work out[…]